best ink for sublimation printing,low price sublimation DTF printer,sublimation ink for epson printer

Due to the working mode of the inkjet printer itself, the place where the printer is placed must be a horizontal plane. Tilting will not only affect the printing effect, slow down the working speed of the nozzle, but also damage the internal mechanical structure. Do not put the printer on the ground, especially on the carpeted ground. It is easy for foreign matters or dust to fly into the machine. This article mainly introduces six aspects of inkjet printer maintenance.

Take dust prevention measures

When the printer is working, do not open the front panel. For one thing, the printing does not look good, that is, the nozzle is moving around. For another thing, do not blow dust into the machine. After printing and cooling for half an hour, cover the dust cover immediately and do not leave it empty in the room.

Turn off the machine before unplugging

Before not using the printer or moving it, it is necessary to cut off the power supply of the printer (if any), reset the nozzle and cover the ink box, and then unplug the power line and signal line. Prevent the ink from volatilizing, and it is not easy to damage the nozzle when moving.

Carefully install the cartridge

The support mechanism of the ink cartridge can bear little force. Be careful when installing a new ink cartridge. According to the normal design, the ink cartridge can be installed with appropriate force. Do not push the support vigorously.

Timely cleaning

Both the outside and the inside of the printer should be cleaned regularly. Don't wait for a thick layer of dust to accumulate. If something goes wrong, you can remedy it. The outside of the printer can be wiped with a wet soft cloth. The cleaning liquid must be neutral substances such as water, and alcohol must not be used. The interior shall be wiped with a dry cloth as far as possible, and shall not touch the internal electronic components, mechanical devices, etc.

Printer internal maintenance

The nozzle cleaning should not be done manually as far as possible. The way is to use the software-controlled print head cleaning program to complete it. Especially after adding ink, be sure to clean the print head to prevent solidification caused by the mixing of the two inks. In addition, if the print quality is degraded during printing, such as stripe stripes and color fading, the nozzle also needs to be cleaned.

If the software cleaning method fails, it proves that the blockage is serious, which is usually caused by the printer not being used for a long time or the power failure during use and the nozzle not being reset. It is a kind of ink-saving cleaning method to keep the syringe facing the nozzle and constantly pull the pressure device to let the high-speed airflow clean the nozzle and suck out the remaining ink.

If manual cleaning doesn't work, you should be ready to disassemble the printer. First, turn off the power supply, unplug the plug, and completely disconnect the power supply. Disassemble the moving shaft and rotating belt, carefully pick up the print head, and rinse it with distilled water. Then use a syringe and a soft hose to form a spray system and insert it into the ink hole for cleaning. Be extremely careful in both steps. Never let water touch the circuit board. If the circuit board is unfortunately wet, it should be dried immediately with an electric hairdryer.

Avoid heavy pressure on the printer

Some people often put other objects on the printer, which may crush the printer shell, and some small things will fall into the printer. Of course, drinks and teacups are forbidden.

Make a purchase of best ink for sublimation printing,low price sublimation DTF printer,sublimation ink for epson printer from China, you can get them at a good price if you have a large quantity. We are the thermal inkjet printer manufacturers, hope to be your long-term partner.